Questions & Answers for: Saturn wiper arm

...wiper arm. This is about 44 bucks at getsaturnparts.net. The problem is getting the old wiper arm off without breaking the rear window. The corrosion between the wiper arm and the motor output shaft ...

...wiper arm and hold it for a second or two while you turn on wipers. try this a few times to realign wiper arm timing. the shaft of the motor has a nut that often gets loose. just open cowl under the ...

...wiper arm. The connection of the arm that moves should be checked for being at the correct angle for parking. Removal & Installation 2000-03 Wiper Motor and Bushing Replacement L4-2.2L (Vin F) ...

...wiper arm flipped up and i think got bent/broke somewhere inside during the car wash. The arm now is very loose and 'wobbly' compared to the passenger side one - I hope it just needs tightening and ...

...wiper arm off. Is there a trick to getting the arm off the splined shaft? Do I need a specific tool? Thanksl There is a little lock on the wiper arm. Lift the arm up and slide the lock lever over and ...

...wiper arm up, pull the wiper back then pull it hard down the wiper arm once the loop releases the wiper. SOME PULL OFF SOME YOU SCREW OFF THERE A SMALL NUT THATS YOU CAN SEE AND UNTIGHTENED IT AND ...

...of the wiper arm is a cover that houses a bolt remove the bolt then use a wiper arm puller to remove, they are available at the part stores and inexpensive. Ive used a pitman arm puller in the

wiper arm assembly to fully remove the cowling? Driver wiper works and Passenger does not. Linkage has come apart. before taking all apart check the nut holding on the wiper arm to the spindle, should

...wiper arm My driver's side wiper arm keeps getting stuck underneath the passenger's side wiper arm. Every time I turn the wipers on, this causes the passenger side wiper to lift up off the window and ...

...wiper arm not just the blade so that I can change the wiper motor. flip the nut cover back up the arm and undo the nut shown the arm base is normally on a splined taper so you may need a flat blade ...