Questions & Answers for: whirlpool washer stuck on sensing

...whirlpool gold dishwasher gets stuck at 53 minutes every time and the "sensing" light is on.. It runs continuously, but it stays on 53 minutes remaining for over an hour. Thanks; John ...

...Whirlpool stacked washer and dryer combination. The water is overflowing on the washer. It happens during the rinse cycle when the water is filling up. It appears that the cycle gets "stuck" in one ...

...Whirlpool Ultimate Care II washer doesn't drain. Everything else works fine and it goes through the complete cycle. I took off all hoses & found no blockage (once drain hose is removed, water ...

hi i have whirlpool 6th sense washer and it will not start a prog or door will not open can u help please the door lock is stuck shut the door lock needs to be replaced

washer saying f 50 whirlpool cabrio f50 is a stalled motor fault. try to move drum freely. if stuck look and see for anything obvious. another problem could be the rps sensor not sensing the motor ...

whirlpool 6th sense stops at 1 min and doesn't finish wash cycle The wash works and at 1 min it stays frozen. When I push reset/pump it will run that cycle and again gets stuck at 1 min. I can&

...Whirlpool Duet front-load washer F02 usually means it is taking over 8 minutes for the washer to sense that the rinse or wash water has drained, which either means that the drain/filter is clogged or ...

Washer stops during spin cycle with a "Lo" code. When i attempt to spin with my hand it doesnt spin smoothly at a certiain point in the rotation. That error means that it is sensing an OVERLOAD. If it

Whirlpool Cabrio washer stuck on sensing the load Our washer is not getting any further than sensing the load. It senses for about 15 minutes and then just shuts off. We have had it for about 1 year ...

...but if i turn dial to just spin and drain it works just fine Shift mode sensor Orange thing at bottom of washer stuck on spin not shifting for agitation common in Whirlpool & Maytag and few ...