Questions & Answers for: wheels binding

...does not return to neutral position after turning. The wheel has to be pulled back to straighten the wheels. How do you remove the steering shaft? sounds like it could be the ball joints binding ...

kia sedona steering wheel binds 2003 kia sedona steering wheel binds when turning,possible problem with steering column joints ? yes look there and also inspect your track bar, tierod ends, pitman arm

KEY WON'T TURN TO START CAR. STEERING WHEEL LOCKED, WON'T GO TO NEUTRAL EITHER. It sounds like the steering wheel is binding up the ignition. While turning the ignition key, turn the steer wheel back ...

...being applied and the transfer case lever may bind. The condition is caused by the front and rear wheels turning at different speeds because of unequal tire pressures or turning. The transfer case ...

...is binding, no noise from pump, and full of fluid. Seems to be a sweet spot when wheels are strait, but catches when turning steer wheel mostly to the left. check steering linkage for wear and ...

...wheels , make sure the cable is not binding or frozen , pull hand leaver on three clicks, adjust cable till brakes just start to bind, release hand brake and check the wheels are free to turn. Drum ...

Why is my front driver side tire binding in 2 wheel drive Front tire binds going forward in 2 wheel drive, does not bind in reverse, works perfectly in 4 wheel drive, no vibration or unusual noise ...

My Audi A3sedan automatic won't release one wheel it's binding depending on which wheel in front can be brakes --pad broke and wedge between rotor and caliper ,caliper frozen ,transmission coupling ...

What is causing the wheel to bind after tightening? 2007 dodge caravan 3.3 liters replaced the brake shoes on the right side where the parking is found placed brake drum onto the brake shoes, drum ...

i have an older 4x2 gator.sometimes when I go to take off it makes a squealing noise like the brake is on and if it goes about 15 feet it will quit. and it feels like the brake is on. i would say it ...