Question about 2003 Sierra
...wheel drive, the fluid has been changed. Truck says to service 4 wheel drive, and then the electric transfer case switch goes blank, and no 4 wheel drive is possible. Fluids have been changed on ...
...wheel drive does not engage 2000 gmc half ton, 5.3, push button 4 wheel drive. you can hear things going on when you push the button to 4 wheel drive but the front hubs arent locking in. replaced the ...
...wheel drive message on dash is this a routine check or is their a problem If there are no obvious issues - you would need to get the car hooked up to a computer to pull the codes.. Then you will nkow ...
...Wheel drive not functional Under hood fuse that controls 4 wheel drive blew. When replaced new fuse, truck feels like it is in 4 wheel high. When I removed fuse, truck is in 2 wheel/ With Fuse in ...
...transferring some of the spin to the other wheel(s). What it basically means is that driving conditions are not optimal so if you see that message, be ready for some sort of weirdness while
...wheel drive and says "sevice 4 won't go into 4 wheel drive and says "sevice 4 wheel drive" happened last winter too when I really needed it. I have this problem too, from time to time, it ...
Question about 2007 Yukon
...Wheel drive message , plus the stabiltrak message and when I drive from a stop and start to accelerate , the car jerks at low speed during a gear change. Yukon 2007 Before to worried so much, I ...
Question about 2001 Yukon
...wheel drive there are no lights on saying if im in 4 wheel or not it light went on in message center lastnight when i was in 4 high during a bad snow storm can you please help me figure it out i have ...
Question about 2004 Sierra
...wheel drive message comes on and no lights for 2and 4 wheel drive come on. On my 2004 gmc Lights on dash dont come on. Used to have truck off then back on to put into 4 wheel drive now no lights work ...
...drive wheel slip is noted while the brake is not applied, the EBCM will enter traction control mode. The EBCM uses a 5-volt pulse-width modulated (PWM) signal to request the PCM to reduce the amount ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions