Questions & Answers for: wfd 1060 Ovens

RF214LXTS 0 I have a whirlpool stove, have power on both incoming legs. the top works fine, but the bake and broil elements in the oven dont work. the saftey fuse on the back seems to ohm out good as ...

I turned on my oven to 350. It heats up to that temperature, but a few minutes F 3 comes on the info panel. Hello Lynn, The F3 error code means the oven tempature sensor has became defictive and needs

My oven displayed F5 then F3 code I believe after a nearby lightning strike, When installing new sensor with supplied wire nuts I found black marks on oven side connector. Immediate F4 error code when

GR448LXPS ERROR CODE E2F3 Hello, The F3-E2 error code means that the heated well above the setting the tempature was set at. The usual reason the oven would over heat by so much is a defective oven ...

All the functions works well, but after a few minutes the oven stops and display "F2". The screen is well, the temperature selector, timer, clock, all works well but the oven stops ...

buzzing and f2 showing on display panel Hello, The F2 error code means that the over overheated by at least 100 degrees above the tempature that was set at the time. The usual reason the oven would ...

My oven is comimg up with the F4 fault message? Hello Rose,Hello,The error code F4 are code that mean their is a problem with the oven tempature sensor and that sensor is uncappable of telling the ...

EO F2 The oven will not start or stop. I can not get the oven to work but it will beep with this EO F2 message sometimes. Hello Sonya,The E0-F2 error code means that the oven temperature was higher ...

where is thermostat located in Frigidaire wall oven? Hello Brad,The thermostat is a small diameter appx. 6 inch long round probe it looks like this To test it for proper functionality ya need to use a

Service Code F-3 Hello,The error code's F3&F4 are codes that mean their is a problem with the oven tempature sensor and that sensor is uncappable of telling the control board what the temp. is