Questions & Answers for: wd jumper

...WD hard drive. What should I do? I have had a different problem with this product. But, I have read many postings on its problems. It seems that for certain hard drives the jumper should be set for ...

WD drive won't work as master when Seagate 80GB drive connected as slave. New WD1600AAJB as master - works fine alone. I want to use Seagate 80GB as slave. Won't go. Computer stalls on start up. Both ...

WD hard drives, please give me some solutionrive Problem u ll have a jumper which is located at the back where u hv ur power supply pin.. there u ll hv one pin with 6 needles on which a plastic jumper

...jumper on the wd drive, the bios will not recognize the wd drive even when formatted (get a "drive failed) message). Sony tech support was no help. if you want to connect two hard drive together then ...

...the jumper blocks plugged in wrongI i have To use the WD 800 as a master there must be no jumper attached to it.The maxtor has a diagram for the jumper and it MUST be set to slave not cable

...jumper shunt received with new drive to 'set jumpers' but existing drive doesn't have jumpers set. What's the difference between the BEVT and the PVT HDD? Any tips are welcome. Thnx ...

factory jumper setting for WD 20EARX FACTORY JUMPER SETTING No jumpers is the factory settings on an SATA drive

what jumpers are for slave Western Digital WD Caviar Blue WD3200AAJS - hard drive - 320 GB - SATA-300 SATA SATA drives don't need jumpers. Just install the drive and the computer will assign a drive ...

WD 3200AAJS jumper settings for slave Sata drives have no jumper settings. The computer will find it when you install it.

western digital wd2500bevt slave jumper settings Which jumper setting is for slave SATA drive position is determined by the plug on the motherboard, not a jumper. Jumper settings are for PATA drives ...