Questions & Answers for: Raypak wc 10

...to propane what should be the line pressor on my 175btu heater .It yrun on and off but the comming out is not very hot and it runs for about 3 mins and turn off 10 - 14" WC if memory serves

rp2100 turns on but shuts off within 10 sec bad or dirty flame sensor

My unit fires up, then goes out after 10 seconds. Fires up again in 15 seconds, then goes out again. bad or dirty flame sensor

raypak pool heater, 385000 btus about 10 yrs old on a milli volt system not igniting if gas ok replace pilot generator assembly

heather starts then stop within 10 seconds check flame sensor if 120 volt check wiring or reverse wires

spk display and heater does not turn on heater is 10 yrs old.Rusty inside.spk comes on and it does not light.should I fix or replace? replace you got your money out of it

What could cause A Raypak 336a heater brand new i get a (pv output fault )will run for 10 min then shut off if wired 120 volt see wiring on inside of front panel also check gas pressure sounds like ...

...10 bucks. then you need to clean the burners and inspect the heat exchanger and venting check gas pressure if inadequate heater will soot and overheat if gas ok you might need a chimney to prevent ...

Is there a way to purge air from the gas line?. Pilot won't light. Yes, ventilate the room very good during and after the procedure. No Smoking. No electrical appliances within 10' should be On. Do ...

I have a raypak 156 above ground heater.Is it OK to turn off the pump while heater is running? I want to only run the pump overnight using a timer. Is this a common practice? Can I rely on the water ...