Questions & Answers for: water level sensor fisher paykel

Question about GWL11 Top Load Washer

2 Answers

...was "stuck". I cycled the washer without clothes and it worked fine. Still working after several loads of laundry. The water level sensor will probably need replacing sometime soon. I don't think ...

Ad

Question about GWL11 Top Load Washer

1 Answer

...and paykel mw511 Help the lights keep on flashing (water temp) hot and cold this happens once the water reaches its level what does this mean ? temp sensor is bad or dirty with hard water ...

Ad

Question about Fisher & Paykel Washer

1 Answer

I am trying to wash a load of clothes. Used it yesterday and it worked great. Water level sensor not sensing. Check the small tube that connected to switch. switch off power. Remove the tube and refix

Question about GWL11 Top Load Washer

1 Answer

...before it fills then you have a fault with one of 2 things. - the water level hose is (blocked) or more so the lower p.c.b board is broken and needs to be replaced as its water level sensor is

Question about WA37TG1 Top Load Stacked Washer / Dryer

1 Answer

...water level sensor as the water should not get that high were it goes over the top the sensor should cut in and shut the water off at the level you set. The problem can create more and can be ...

Question about GWL11 Top Load Washer

1 Answer

...water level and can blow bubbles with it so i dont think it is blocked. This happens regardless of whether i use the auto or set water levels., or Hot or cold water. The auto water sensor is in the ...

Question about Fisher Paykel Intuitive Eco Washer IWL15

1 Answer

...water level, The plastic hex with red on it needs to be turned up to raise & down to lower the water level.1/8inch of a turn will adjust water by 15 to 20mm. 66. (01000001) Pressure Transducer ...

Question about GWL11 Top Load Washer

1 Answer

...water- not normally heard. Another possibility is the inner bowl is not level when empty, tho the outer machine is level. From left to right (0=on/lit up, X=not lit up) the code appears to be #234: O ...

Question about GWL11 Top Load Washer

1 Answer

...water level more than 4 times during wash/rinse cycle. Most likely cause is waster siphoning out or the machine has developed a leak. Primary Source: Drainage system. Action: Check that the hose is ...

water and shuts off. I have tried getting diagnostic info from the manual but not helpful The machine will not start the selected wash cycle until the desired fill level is reached. The fill valve and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...