...machine? The LE error code means that the motor sensor has failed on your unit. It's a small sensor that is attached to the motor in the back of your washer. You will need to order that motor sensor ...
...stator. Unplug the unit. Remove the back panel exposing the rotor, using a 19mm socket, remove the rotor. The wire harness is clipped there so unscrew it. Using 10mm socket, unbolt the stator, ...
...washer. Gw609 The machine starts to fill with water and in about 10-15 seconds starts beebing with only the first green light of the long cycle and the the two lights of the spin cycle on. I can not ...
Question about Fisher Paykel Intuitive Eco Washer IWL15
...Washer that also knocks and takes a walk when it is in the spin cycle. The machine is level and is on a concrete floor. It also appears that the tub inside is weaving side to side when it is in the ...
...machine. so far the drum position sensor, drain pump, and stator aasy. have been replaced. Still have an le code. I have power at all three wires at the stator assy. Please help. Our LG WM0532 front ...
machine for 30 minutes to let the motor cool down. Then, restart the washer. If the code comes back immediately the motor is not likely to be at fault and so you should check the wiring from the motor
Question about Atlantis MAV9750A Top Load Washer
...washer for later use if needed. If the drive pulley is reinstalled correctly, a groove will be visible at the end of the drive shaft for the retaining ring to go back in place. 13. Reinstall drive ...
machine for 30 minutes to let the motor cool down. Then, restart the washer. If the code comes back immediately the motor is not likely to be at fault and so you should check the wiring from the motor
washer wont agitate, tub just spins during wash cycle you have a bad bad break package which is mounted above pulley located on bottom of machine.special tool required.Hope this helps .pleases rate my
Question about WM0642H Front Load
washer and found a completely dead control board and a soaking wet load inside. This machine is repair friendly and for the most part, durable.Stop using it to prevent additional damage. If you are up
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
