Question about Neptune MAH5500B Front Load Washer
...washer and dryer (MDG5500A) dead except for drum lights. While both machines were operating a loose connection in the breaker panel caused an over voltage. The ceiling light on the same circuit would ...
Question about MAH6500 Neptune Front Loading Washer w/Built in Water Heater
...washer and then replug after 5 minutes and see if it reboots! Since I can not have hands on inspection of your dead unit I can not tell which of 5 problems it may be! There is a good nation wide ...
Question about Neptune MAH5500B Front Load Washer
...washer. If you have a dryer or other metal object that is grounded (Bonded) you may get a shock from it, also standing (barefoot) on a concrete floor may cause the same. ( bonded is a gronded ...
Question about Neptune MAH5500B Front Load Washer
...washer has restored power, but the cycle still would not complete. when the repairman comes out, he finds nothing wrong and says the cycles complete. check to see if the water is warm if not the ...
Machine is dead and door is locked I put a load in to wash, and when I came back a couple of hours later, the machine was dead and the door is locked. Nothing happens when I press any of the buttons ...
Question about Neptune MAH5500B Front Load Washer
...washer appears to be dead. No lights come on at all. I cannot get any error codes at all after pushing the buttons it says to push in the manual. I used the washer just last night and it worked fine. ...
...are having the same problem. What is your solution. Thanks Willie Wash it with bleach, that will kill the mold dead. do it once a week when you wipe your washer down you will be in charge of the ...
Question about Neptune MAH5500B Front Load Washer
...Washer is dead and they want $400 to replace the main board. we now purchased another washer (not maytag), but now have the dryer sitting on top of this dead maytag washer can we separate the washer ...
Question about Neptune MAH5500B Front Load Washer
Neptune Maytag washer wont fill with water Check to see if your valves are on. If they are, they might be clogged or the pump is obstructed/dead.
...washer is just dead. It's like not doing anything. Its like no power at all. Check to see if the main panel circuit breaker is popped by switching it off and then back on again and there should be ...
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions