Questions & Answers for: LG WM washer dead

Question about WM2487H Front Load Washer

1 Answer

...washer is completly dead we have aquired a washer that a servce tech claimed to be unfixable after 3 attemps a water valve and 2 circit boards.The machine now has no display and has no response,all ...

Ad

Question about WM2277H Front Load Washer

1 Answer

...washer for two hours. Plug it back in and try again. The problem actually is a small trigger on the lower side of stator that acts as a trigger to provide feedback to the motor controller. One of the ...

Ad

Question about WM-2277HW Front Load Washer

1 Answer

...washer beware if you put another fuse in and it blows again the you have a dead short on the board someware also make sure you use the same rated fuse the value will be on the end of the fuse or on ...

Question about WM2277H Front Load Washer

1 Answer

house fuse blew and now there is no power on LG WM2277H washing machine Did you replace / reset fuse? Turn on washer again if it blows unplug it, unit has a dead short inside.

Question about WM-2032H Front Load Washer

1 Answer

...washer is dead. Was getting frequent PE error, but most recent wash completed fine. That was about 2 days ago. Tried to start a load and there is no response. No lights, no error codes. It has power. ...

Question about WM3987HW Front Load Washer / Dryer

1 Answer

...dead, unplugging and replugging won't work; outlet has power Hi Rick, I found your answer to another person's problem with the LG washer/dryer not turning on. We have the same problem. My husband ...

Question about WM2450HRA 3.7 CF Steam Front Control Washer

1 Answer

no power on machine outlet is fine Was having similar issue. Unplugged for about 15 minutes and plugged back in and worked for a couple days. Then it was dead again, unplugged again and working again.

washer (Lg tromm Wm2377cs) is coming on by itself when the door is open. The panel stays lit, then eventually goes dead, only to come on again later by itself. Do I need a new board & if so, where

...Dead! And your Tub may be a goner too! Depending on the extent of damage, you said you saw SMOKE! I never seen smoke from a washer unless someone throws a Concrete Block Stone in one on You Tube! ON ...

...washer with water? I have cleared out the filter, remove the pump it it looks clean. Nothing around propeller. I remove drum drain hose, it's clear.I think my pump might be dead, I hear a humming ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...