Questions & Answers for: Roper washer dead

washer will wash but will not advance after draining wash will not fill with water and advance, but if i move back to wash it will fill with water and if i move it to rinse it will complete cycle. ...

...washer is dead. it has water and laundry in it. Is you washer sitting on a carpeted floor? If so ther is not enough air flow under it for the motor to not overheat. Maybe by now 4-3-09 it's ...

...line) have some towels ready. The pump will just come off but its not usually an issue one top load washers unless its leaking. A no drain issue if the unit is totally dead is more than likely an ...

dead spot on the timer, but this is doubtful. Check your lid switch. The symptoms of your washer stopping at the rinse cycle is a commonly caused by a lid switch malfunction. The lid switch is usually

washer will not spin. The pump is mounted on the motor. In the wash cycle the pumps turns counterclockwise. In the spin cycle the pump turns clockwise, forcing the water out of the machine. So if that

...washer fills, if the machine does not agitate, but stops dead, you have a broken lid switch. When I say stops dead, I mean no noise whatsoever. If the machine makes noise you have other problems. If ...

...washer and Boom she washes her rugs in a low water setting. That tired old drive coupling that has bee hangin in there all these years has gave up the ghost. Pop them pump clamps and remove that pump ...

my roper is full of water and quit in the middle of a wash cycle?? It appears to be dead .. I cannot get any noise or sign of life from it. It's only 18mos! :(e look at the breaker at box. if not ...

Some problems w/hot water Run hot water all the time.I' check both hoses and connections attached to the wall. Your mixing valve sounds like it is dead. Pretty easy fix! Do some Googling to find out ...