Question about GWL11 Top Load Washer
Dead------blows main fuse when rinse starts I replaced the on-board fuse with a in-line fuse and holder 6 amp...fuse blows in 3 seconds when rinse cycle starts. I suspect a bad motor.....any advice on
Dead Fisher & Paykel GWL11 Washer Got an error code indicating a problem. Started washer to pump the water out. When I tried to start it again to run the diagnostics in was completely dead - no lights
...washer press power button but nothing happens. you have a blown main power module I can talk you through testing this machine for a secondary fault and replacing the module in live chat Controller is ...
...washer, added soap went to start but was dead. It worked a couple of days ago. It's not the breaker...I tested that. Tried to unplug and replug, still nothing. ok You have a blown Motor controller ...
Question about Fisher & Paykel Washer
...washer is dead -no lights nothing is there a fuse or reset button on fischer paykai top load washers. had a power failure and now machine is dead. the machine was not in use at time of outtage but ...
washer all of a sudden its dead, no power going into machine. checked all house fuses and they are fine so most likely to be the washer. I have the same problem with my GW52F, i have checked the power
...washer stopped in the middle of a wash leaving the clothes soaking wet and now the power button does not work Either the computer board is dead OR the pump was on it's way out & took the board ...
...plug now check the fuse inside the washer power supply it's glass type make sure you use the same rated fuse beware if it blows again then theres a dead short in the washer hope it helps regards ...
gwl11 will not power on Turned it on while leaning to see if pump was working. Washer turned of and now it is dead. It could be the 4Amp fuse in the motor controller board that needs replacing.
Question about GWL11 Top Load Washer
washer - no control panel lights, just dead Quit in mid-wash cycle (didn't spin) No lights, no response from control panel. Reseated control board - still nothing. check for dead pump if good the main
Usually answered in minutes!
1,514 Questions
200 Questions
88 Questions
87 Questions
45 Questions