low won't start. replace battery and when I try to start it make a clicking sound. how manny volt is the battery? If I understand the question, the battery is 12 volts, but if U put a volt meter on it
...Volt range and start the bike. Bring the engine to a high idle. Put either of the meter probes on one metal contact and the other probe on the other contact. The meter should read 25 volts or higher. ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...low charged over night and am going to check voltage and amps at battery while running today. What are the telltail sighs of failure. Thanks, Alex With the battery fully charged, use a DVOM (digital ...
Question about 2001 FLHTCUI Electra Glide Ultra Classic
...are the ac reading coming from stator at 2.5k rpm 3k rpm and 3600 rpm. At 2000 rpm I get about 12 volts dash guage reading but at 3000 I get 13.5 to 14 at lower rpm 2000 or so I don't get ...
Question about 2007 FLHTCU Ultra Classic Electra Gilde
...low battery symptoms Hi Anonymous, perform the following tests: 1. Fill acid type batteries to proper levels. 2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging. 3. ...
Question about 2007 FLHTCU Ultra Classic Electra Gilde
1970 XLCH generator. It s only putting out 1 1/2 - 2 volts. I have taken it totally apart and cleaned all contacts, trued the commutator, put it back together, with no better voltage. I am not sure I ...
...low battery Hi Anonymous, perform the following tests: 1. Fill acid type batteries to proper levels. 2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging. 3. Make sure ...
...volatage low with a new battery Hi Anonymous, either your battery did not come fully charged 12.8 volts or will not bench charge to 12.8 volts in which case you should take back to place of
ignition voltage check Hi Anonymous, your battery should be charged to at least 12.5 volts or better. That voltage should remain the same to every major component in the ignition circuit with a drop ...
...low U1301 = Serial data open/high Serial Data Low or Serial Data Open/High.The typical serial data voltage range is 0 volts (inactive) to 7 volts (active). Due to the short pulse, voltages will be ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions