Questions & Answers for: 5 volt is low

Ad

1909 buick skylark tps low volts trouble code have a 1990 buick with 8oooo miles car wouldnt start replaced ecm ran a couple weeks check engine lite came on, trouble code low/high volts on tps. ...

Ad

inverter output voltage (eg. 96 volts) not if this is an issue I just installed a used solar system which included an Xantrex 2412 inverter with an Outback charge controller. The system includes about

Ad

Question about DR2412 Inverter / Charger

1 Answer

...low volt trans will have 115 volts.The other side should have 24 volts.Going to the heater.The t stat completes this circut when calling for heat. Some units have a reset on them or a small control ...

Question about DR2412 Inverter / Charger

1 Answer

...volt-swith works it seems as the low pressure switch or an electronic board is the suspect. how can I test which part has failed If you put a jumper wire across the low pressure switch and unit runs ...

Question about DR2412 Inverter / Charger

1 Answer

...3 prongs were 12 volt on hight beam on low beam one prong goes to 6 volt and the other two stay at 12 volts. Could be a defective headlight relay, Located in the fuse block in engine

Question about 2000 LeSabre

1 Answer

LOW VOLT IN THE 12 VOLT RANGE WHAT SHOULD THE CHARGE VOLTS BE most charging systems run between 14.5 and 16 volts if the regulator is working fine..battery voltage only means that the alternator is ...

...6 volt 6.5 to 7.5 volts for 12 volts 12.5 to 13.5 if low voltage go to voltage regultor if volt or low go to generator test there if low replace gen if voltage ok generator replace voltage ...

...low voltage 0ut of 120 volt receptacle only 5 volts at idle and 45 volts under power have the alternator checked by an electrician a t idle will be low as the exciter circuit will be producing low ...

What is the difference between 12v high current 12v low current thank you John. volts is potential so high /low is immaterial as it is 12 volts reference to high / low could be the current flow which ...

...volt reference circuit, a low reference circuit, and a signal circuit. The control module supplies 5 volts to the BARO sensor on a 5-volt reference circuit, and provides a ground on a low reference ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22486 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...