Questions & Answers for: vga save

...Save the BIOS turnoff the computer and plug the monitor into you vga card. That should do it. To change it back to your motherboards vga just reverse the instructions. Let me know what happens. Good ...

...save mode" in a blue box then it goes to sleep. Any perticular reason why this may be occuring? Are you connect via Analog (Blue VGA connection) or DVI (White Digital connection? If you are connected ...

...The monitor doesn't receive the signal from the PC. It is either the PC not booting up or the VGA coard is faulty. Change the VGA coard. or try reseting the VGA

...one, but only if I am certain it is not something easy to fix. Thanks Tom Bozeman Montana Check the VGA cord that connects from the PC to the LCD, try putting VGA cord properly to the LCD and PC, or ...

...is moved. It's not on power saving mode, it does not sense that it's already is plugged at your VGA. The only thing to test it out is to have another monitor/computer *to see which one is not ...

...and disable onboard vga . Then save settings of bios and exit. Then your onboard vga is disable so you can install vga card into it. Let me know if you need further assistance. Thanks for using

...of restarting the compujter to finally get it working. It will happen when your are using two VGA card adapter plug-in into your computer. The one is built-in and the other one is plug-in into ...

...vga driver,,when it asked you where to download it to go to the usb device ,,dont run it,,save and download,,then put it on your laptop,,you may have to connect laptop to a tv or other device so you ...

...in the mother board, still has the same results. The message it is displaying indicates that a VGA cable is connected and is not sending signal, or is sending a Monitor Off signal across the VGA ...

...cord between the monitor In the center of the screen it reads: D-Sub out of range 68.5Khz/85Hz VGA Port or Power saving mode HDMI Port I have a LG Flatron E2750v Monitor connected with dist tv ...