Questions & Answers for: vertical deflection tv

vertical deflection. Thank you for your help...Ralph Watson You have a bad vertical output IC, or the sweep power supply that drives the IC is bad. Your going to need the service schematic diagram and

vertical deflection ics. I investigated with an oscilloscope and found that pin 22 of the main ic, X2933ce, has no output drive waveform going into the vertical deflection chip. There is not even a dc

...vertical deflection. (Sound OK.) No vertical is always an affordable fix. - failed (dried out) electrolytic caps in the vertical circuit - failed vertical IC - failed power to the vertical circuit. ...

...vertical deflection. This might be caused by the vertical coupling capacitor going bad, or by the vertical deflection coil on the yoke transformer going bad. In any case there is not enough vertical ...

vertical deflection went out and now HV is going into shutdown I replaced the vertical deflection chip and it worked for a minute then went out again. I don't have a schematic and I noticed that ...

...vertical deflection circuit. This is more then likely the result of the vertical coupling capacitor failing. You will need the schematic diagram of the TV to find the capacitor in question. it is ...

deflection. The vertical chip is probably fine. Check connections around yoke (thats the connector with at least four wires that goes up to the coils around the neck of the tube) Maybe that TV has two

...vertical deflection.' If all you have on the screen is a single horizontal line, the vertical deflection circuit (or IC) has died. Unless you have service documentation on hand, I can't give a part ...

...vertical deflection No vertical deflection, just a line in the center. I don´t have the diagram. Tanks Look up for faulty Elkos in the vertical Stage near the powersuply abd then find the ...

...is checked , check for weak capacitors near the output vertical drive. Also a faulty vertical coil- deflection coil- can result in half picture.A vertical signal test can