Questions & Answers for: valve seal

...head gasket Cylinder base gasket Fresh bore on cylinder (if it can be bored), see note Possibly valves, valve guides and valve seals, see note Miscellaneous seals and gaskets NOTE; some cylinders ...

Ad

...valve seal that is expensive and if the head gasket is leaking,expensive.look at the outside edge of the valve cover,and check the edge for oil.if there is alot of oil,by the time the plug is ...

Ad

Question about 2002 Altima

6 Answers

...VALVE STEAM OIL SEAL KIT. SET OF SPARK PLUGS. THEN THE HARD PART OF WITH THE CYLINDER HEAD .THEN VALVE SPRING COMPRESORS TO REMOVE THE VALVES. THEN D COKE THE CYLINDER HEAD I PREFER TO USE PAREFON. ...

Question about 1999 Silverado 1500

1 Answer

...Seal (6)A/C Valve (7)Heater/Defroster Valve (8)Temperature Valve (9)A/C Valve Lever (10)Mode Valve Actuator (11)Heater/Defroster Valve Lever (12)Mode Valve Cam (13)Lower HVAC Module Case (14)Rear ...

Question about 1998 S70

1 Answer

remove the old cam shaft bearing cap seals. Replace the bearing cap seals and the valve cover seal and replace the cap and cover. Tighten the bolts to about 30 lbs and that should resolve the problem

...valve seal replace can valve seals be replaced without taking head off? Yes and no.Depending on how the lifters and rocker arms sit on the valves, you might be able to apply air pressure to the ...

Question about 1998 S70

1 Answer

...can be purchased at a good hardware or plumbing supply store. Use the valve handle, below the tank, on the pipe that comes through the wall, to turn off the water before replacing the seal or

can I fit valve stem seals without taking the head off on 1600 sentra 1997 Can I fit valve stem seals without taking the head off No you can't.. Fitting valve stem seals involves removing the valve ...

...valve seal conditioners that may help and what brand do you recommend? Any help or opinion on this would be greatly appreciated! Really not looking forward to spending $5000 on re-building the head. ...

valve stems seal failure along with cracked /broken seal rubber However if you are really mechanical minded, remove the cam shaft/s for each valve in turn place a tool in the plug hole under the valve

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...