Questions & Answers for: valve rattle

reg. oil - their is only a 1 percent difference between them) a rattle noise could be a valve rocker arm OR (the rattle i had) the catylitic converter. the honey comb stuff broke up into pieces inside

...valve spring will cause the valve to "float" and make a rattle noise...as well as excessive camshaft end play. Make sure your valve train is getting proper lubrication. Good luck....i hope this ...

...rattle soft and as i accelerate it rattles hard check oil pressure possible valve tapping -start vehicle and open hood if the noise is on top and sounds like metal tapping u may have a problem with a ...

...shake it, if it rattles it is okay, if you don`t hear a rattle it needs to be replaced. Also I personally would change the pcv valve every 25,000 to 30,000 miles because they are usually

...valve rattle or pinging noise. I'm just cruising down the road at 55 miles PH and the pinging rattle starts, like it is coming from the valves in the truck. I've changed the oil two times now in the ...

...to be reburned. Once the egr valve is off it should rattle. If it doesn't you can clean it with carburetor cleaner or other. Sometimes just replacing it is quicker in this disposable society we

oil pressure light comes on and valves rattle after warmup after about 12 miles on a warm engine oil pressure falls and valves rattle Sounds like a failing engine. Assuming the engine is full of oil, ...

....002 to .004 with valve fully closed(Heel of the cam lobe). You should be able to slightly rattle the rocker arm. Don't go to tight.(No noticeable rattle) Too tight will result in a burned

...body replace an EGR valve, replace the muffler and still the problem persist. rattling like a vaslve rattle--if so need to pull valve covers and check the rockers,push rods ,basically the valve ...

Kawasaki vn800 rattle when under load need to search for rattle -use a rubber mallet to tap frame in different areas for noise ---or if engine rattle low oil burnt damage valve -valve train