to much iol my punto 1.2 8 valve had to much iol put in changed the rockre gasket and drained the iol put back to the right level changed the leads and pluhgs. engine is still misfiring their is still
2000 fiat seicento, problem with powersteering losing power also the speedo stops working at same time. this is a intermittent fault. power steering is electrical and is situated at top of steering ...
and relay now won't start atall????1.9td scudo pre heate light comes on and goes out...fuel cut off valve seems to be working? but just turns over? 1.9 td scudo..r reg....new glow plugs and rlay... Do
...carb car i have good compression good spark # 4 cyl not fireing? car starts and runs with a miss valve clearense is + - 3000 Take a couple of minutes and move the #4 sparkplug to another cylinder ...
I have a Fiat Palio 2002 and off late I find the gear shift getting stuck - means I cannot change gear when the engine is running. The gear is smooth when the engine is off. the clutch plate is burnt ...
...starting the car up. any advice would be greatly appreciated. It sounds like the air bypass valve is not closing after warmup and this sounds like a temperature related problem. Air bypass is ...
...01 oil leak on Rocker Cover Gasket Area. New one placed but still leaks. Any ideas Possibles here. Valve cover is too tight. If you used sealer on it, it could allow the gasket to slip when
i would like to know the valve clearances and spark plug gaps for a fiat panda 1.1 2004 model. thanks Spark plug gap should be 0.9mm, valves -inlet (cold) 0.30-0.40 mm and outlet (cold) - 0.40-0.50 mm
car wont start valves do not release petrol Engine has been changed rings and bearings Is this a diesel?
What could be the problem if the valves are burnt What could be the problem if the valves for fiat palio are burnt Most likely cause would be the engine running too lean
Usually answered in minutes!
1 Questions
173 Questions
