Questions & Answers for: Lincoln valve burnt

...on that cylinder to make sure you have at least 100psi. Anything less than that would lead to either a burnt valve or a piston ring issue. Doing a compression check first will save you a lot of

...burnt valve or a bent push rod. The BEST solution is to recondition the heads and replace the cam & lifters. This will insure that any of the failing components are replaced and it will reseat you ...

...burnt carbon from back of car after hard acceleration.Any ideas??-Dave. WELL COULD BE CLOGGED FUEL FILTER.SCAN CAR COULD BE EGR VALVE OR FAULTY FUEL PRESSURE REGULATOR. I had the same problem. It was ...

burnt a valve, you have the right idea for now until the llight comes on and you can locate the right cylinder and then you may end up with a bad coil pack or two, google motorvac and read up a little

...low. Please help. sounds like you have a cylinder with low compression like a sticking/burnt out valve get a compression check done first then check for air leaks on the inlet manifold ie, the ...

...burnt out coil so replaced with new one ran motor new coil burnt out just as the old one IF THE COIL IS COVERED IN OIL FROM THE PLUG CHAMBER IT WILL BURN OUT. IF SO FIX THE OIL LEAK AT THE VALVE ...

...burnt valve , cam followers/ hydraulic followers faulty)---wiring---ignition/fuel system---injector--ECT/MAF sensor ---ECM possible injector fault ( blocked tip) code p 0401 refers to exhaust gas ...

burnt only when car is parked V6 or V8? You've got an oil drip back there. If you look right at the rear of the intake manifold, it might be leaking there,or it might simply be valve cover gaskets. Go

...if the reading is higher points to broken or worn piston rings, if unchanged points to burnt valves or blown head

...burnt] and check electrics related to engine and pcv valve. all checked ok. still runs rough and lacks power. Do a compression test. Maybe that motor needs major repair. Proper plug gap ? and new set ...