...Valet mode. To get out of it, turn the key to the "on" position then back off, and just press your black program button hidden under the dash. The installer should have shown you where they installed ...
valet (black button) one time and release Push and hold valet button Push either lock or unlock on viper remote Key out of IGN Test unit The horn or siren may sound afterwards to indicate SUCCESS!!!!!
valet (black button) one time and release Push and hold valet button Push either lock or unlock on viper remote Key out of IGN Test unit The horn or siren may sound afterwards to indicate SUCCESS!!!!!
Question about Security and Remote Start System (basic install included)
valet button one time and let go 4. Push and hold valet button. 5. While holding button push either lock or unlock on keypad of new remote. 6. Siren or horn should sound. 7. Let go of valet button and
...Valet/Program button.1. Leave the driver's door open.2. Put the key in the ignition and turn the ignition on without starting the vehicle.3. Press the Valet/Program button six times and hold.4. ...
...valet button..........it should be next to led on the antennaTurn key to IGN position...........so all dash lights are onWithin 5 seconds push the valet button 1 time..............may have been ...
Question about 5701 VIPER 5701 2-WAY ALARM w/REMOTE START
... twice then press unlock on the remote. The LED should turn off. OR, enter the vehicle, turn the ignition on then off, press and release the valet/programming button on the antenna. LED should turn ...
Question about 5701 VIPER 5701 2-WAY ALARM w/REMOTE START
...valet button on the Viper 5701 is located on the antenna which is normally installed on the front windshield. Viper calls this button the "control button". Here is a link to the owner's guide: ...
Question about 473v Viper Remote Case Three Button
...remote to a viper 130xv Open door, turn on ignition. Press and release valet switch then, press and hold valet switch. Press lock button on remote. Release valet switch, turn off ignition.
...valet/programming button once and release. Press valet/programming button again and hold it down. With valet/programming button held down, you should hear the siren chirp within a few seconds. After ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions