Questions & Answers for: vacuum hose wrangler

...vacuum? I get good heat, it just doesn't blow! you have managed to disconnect a vacum hose either under the dash when you instaled the blower or you have disconnected the vacum hose under the hood ...

VACUUM HOSE DIAGRAM FOR 1988 JEEP WRANGLER 4.2 I6? I NEED VACUUM HOSE DIAGRAM FOR A 1988 JEEP WRANGLER WITH A 4.2 INLINE 6? ARE WERE TO FIND THIS AT? here is a link with all the vacum diagrams for ...

...vacuum lines for this jeep. It does sound like a vacuum leak. Get a can of WD-40 and start spraying around the carb. It will rev up, and U can pin point the loose vacuum hose, are crack vacuum

...4wd by vacuum. check the vacuum hoses that run to the actuator. Pay close attention to the vacuum hoses running underneath the battery as battery acid can eat thru those hose easily. Good

...hose. Connect vacuum switch assembly wire connector. NOTE: If timing light has an adjustable advance control feature, turn control to OFF position. Timing is set per the emissions tag under

...vacuum hose from the shift motor on the front axle.with the vehicle running,(be sure to set parking break and /or chock tires.) place your finger over the end of the hose check for vacuum,it will be ...

...vacuum system diagram for a 1995 Jeep wrangler? Specifically, the MAP sensor. Map sensor should be a single hose from the sensor to the intake manifold. On the newer ones they attach the map to the ...

not adjustment that can be made. If the idle is to high you have a problem, most likely a vacuum leak from a intake gasket or a disconnected vacuum hose, this extra air causes the engine to run faster

...vacuum hose that plugs in just below the throttle body on my 2000 Wrangler 2.5L. Which hose is this and where does it go? I can't find a diagram for this the 2000 2.5L YJ. All I need is this ...

...vacuum in 4wd system? where does system pick up vacume for transfer case. i know where and what hoses go and do. red hose is open and i cant find a place it went ...