Questions & Answers for: uplander wiper removal

Question about 2006 Uplander

5 Answers

...wiper fuse on the uplander is in the fuse panel inside the vehicle on the front passenger side. The rear wiper fuse is a 15 amp show as number 3 on the diagram in your owners manual. Chances are the ...

Ad

...wiper on the uplander is a common BOSCH unit and is very prone to one very small but very easy ( and CHEAP to fix ) problem. The shaft that goes through the glass on the rear hatch needs to have new ...

Ad

...wiper on the uplander is a common BOSCH unit and is very prone to one very small but very easy ( and CHEAP to fix ) problem. The shaft that goes through the glass on the rear hatch needs to have new ...

...wiper motor located in a 05 Chevy Uplander Should be inside the engine compartment in front of the drivers side little black box... it is located in the back hatch, remove the panel and you will see ...

Question about 2006 Uplander

1 Answer

...Uplander the rear wiper has stopped working, was making a grinding sound before it completely stopped, what are the possible solutions sounds like the gear drive has stripped out the end of the wiper ...

Question about 2007 Uplander

1 Answer

...wiper motor on 2007 chevy uplander FIRST TURN OFF RADIO THEN DISCONNECT NEGATIVE BATTERY. MARK POSITIONS OF WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE PUTSIDE OF THE ...

...uplander 2005 you can ask for a set of printed instructions from autozone. I will say for this job you will need the following size sockets. 10mm 13mm 15mm. for some things a wrench 10mm may work ...

Question about 2005 - 2008 Chevrolet Uplander Brake Pads W0133-1774856 Rear Chev

1 Answer

...uplander The rear wiper motor is accessed under the trim panel on the rear gate. You need to remove the panel ideally with the help of a panel removal tool (like a long flat screwdriver with a notch ...

uplander 1. Remove the rear wiper arm 2. Remove the wiper driveshaft nut( nut behind wiper arm) and the washer and seal from the driveshaft 3. Remove liftgate trim pannel 4. Dissconect electrical conn

...wiper motor 2006 uplander once you get the plastic trim cover removed, you will need to remover the entire wiper arm, then unplug the wiper motor, then remove all bolts, etc that are holding it in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...