Questions & Answers for: how to unplug hose

...hose. Loosen it up, and unplug it, this step might take a little muscle. The last thing you should see are four electrical wires plugged into the valve. Label them in a way so you won?t get confused ...

...Unplug heater. remove hose clips, will need to use hose clamps to replace 35mm Jubilee will do. Plug in to new heater. Fix useing new hose clamps. Refit base, plug in and test. This method works on ...

stops at drain cycle and continually beeps have unpluged for 5 min, no help I had the same problem. I did the following. - unpluged washer - drain washer - tilt back washer on wall. - The problem was ...

washer won't stop filling Does the water stop filling if machine is unplugged? If yes, bad water valve inside washer. If water stops when unplugged, may be a faulty pressure switch or airdome hose ...

...light blinks My spotbot lights would blink and it, for a time, only worked on deep clean even after unplugging and plugging back in. Finally it wouldn't work at all, only the hose light would ...

no suction to seal bag is a hose unplugged? Unplug the devise and see if you can find anything that looks like it's not connected OR it has a hole in the hose. 

...hose from the drain pump has come ratcheted. First of all, make sure you unplug the machine until the problem is sorted — electricity and water don't mix well. If it is out of warranty, and you ...

...unplug it first. Then you will have an inlet hose coming from a tap under your sink , turn the water off and disconnect this hose and drain any excess water into your bucket . then remove your two ...

hose, and unplug the hose that goes from the fuel tank to the engine. This hose should be smaller and should be unplugged at the engine side not the gas take side. Apply a vacuum to the hose (suck it)

...the drain hose a pushed the hose all the way in and we can't get it out Unplug the machine from the mains. Pull the machine out and undo the screws to remove the top. after unplugged un connect ...