Questions & Answers for: Subaru tyre wear wheel alignment

...tyre.  If you can feel one tread block's edge is higher than the edge next to it, then this uneven wear is probably your cause of the noise. Try swapping the tyres front to back.     ...

wheel bearing? also the caliper seems fine. hi it could be bearings first jack the car block it safely and try moveing the tyre side to side holdind the tyre in both hande move it up adn down and side

wheel balance and although not related, one can make the other worse. First off ckeck your front wheels for bends or curb damage. Check the tyres for uneven wear, bulges, or blisters on the side walls

...than just springs. If you lowered the suspension.Yes it does change the steering geometry.This means you need a wheel alignment and that may change the position of the steering wheel.Hope this ...

...wheel alignment and balancing done, they rotated the front and back tyres. the mechanic took the car to another place who said it wasn't done properly, and they changed the tyres back and ...

...tyre wear.. 1---place the wheels in the straight ahead position. Using a spirit level place it vertical across the front rims touching only the rim top and bottom . adjust to achieve the bubble just ...

...alignment issue. I would take it to an auto shop and have it checked out. Most of the time, the front wheels will give more wear due to turning and turning over bumps or even curbs, which will give ...

...shakes plenty too but I'm guessing that's a separate issue with the front rotors. I'v bought new tyres recently, balanced and aligned, but still the same problem. Front CV joints have worn boots ...

...wheel, is it due to the tyre being a different brand to the other 3 tyres on the car? Sounds like a seperation in tire. Inspect outer tread if nothing look for places around tire that not smoothe. ...

...wheel is reckoned safe and legal to take a car at greatly reduced speed to the nearest place where the puncture can be repaired or the tyre replaced. It is worth noting the recommended pressure and ...