Question about 2002 SC 430
...were the Dunlap RFT and they too had to be replaced after less than 10,000 miles.Help!! where did the tyres wear if it was on the inside, outside, or sides only sounds like you need a wheel
tyre wear on this side then first measure outside wheel rim front to back wheel through centre ,both sides and see if distance is more that half a centimetre,look at distance between back of wheel and
...wheel shaking when an acceleration takes place between 40km/hr to 50 km/hr, No loose connection or alignment could be detected.If tyre pressure is 40 psi, the shaking reduces but still exist. What ...
tyre to wear, and under inflation will cause the outer and inner band of the tread to wear. The vibration may be caused by the loss of wheel weights. Maybe knocked off by hitting a kerb which also may
wheel hub run out.check and adjust alignment but problem same. Front and rear impeller shafts?? Not sure if you mean drive shafts or not? The problem could be in your front drive axles/drive shaft. If
Question about 2005 Ls 430
...if your steering wheel is straight, and not pulling, and your tire wear is even, I wouldn't worry about it. Alignments are usually done for those reasons, and for major front end parts
Question about 1996 ES 300
...wear to the outside of the tyre could indicate to a tyre specialist that the car recieves some serious cornering g-forces. but if this SUV is driven carefully then that should not have happened. when ...
Question about 2005 SC430
...a front end "alignment". they will loosen all these joints and will set the wheel straight to match the direction of the car. Over the years, these parts wear and the wheel gets crooked. Be
why trac off warning in rx 350 2012? This could be due to improper wheel alignment or worn suspension or steering components. It may also be due to odd tyre fitment. Check those first.
Question about 1994 GS 300
...wheel could have gotten hit as well causing it to be out of alignment. If your vehicle was repaired after the accident, I would return it to the shop and let them know that you are having issues with ...
Usually answered in minutes!
Step 2: Please assign your manual to a product: