...Two green blinks indicate that you are ready to enter GPS mode, however the sticks are not centred. It should only have one green blink in gps mode or one yellow blink in atti mode if you centre the ...
...blinks green, I tried pushing the scan button but it will not stop the blinking. Also the othere radio beeps when I change channels, is this common? The radios where a gift and work well aside from ...
...two led blinks customer said tv had a power surge and now its pretty much a dead set with led blinking two times. relay is heard but that is all. any suggestions Two-blinks of the "Diagnostic ...
Question about WS-55859 55" Rear Projection Television
...two blinks, a pause and two blinks and the set will repeat the error code about 10 times. 1 blinks and then 2 blinks is NO ERROR DETECTED 2 blinks and then 2 blinks is short protect ETC.....Let me ...
...two blinks, a pause and two blinks and the set will repeat the error code about 10 times. 1 blinks and then 2 blinks is NO ERROR DETECTED 2 blinks and then 2 blinks is short protect ETC.....Let me ...
Question about Aquos LC-37GD6U 37 in. LCD HDTV
...blinks at a rate of two times per min (3.3V Main Failure check power/inverter board or Main board). V) If the power light is blinking at a rate or two times per min and the OPC light blinks at a rate ...
Question about WS-55313 55" Rear Projection HDTV-Ready Television
...then blinked twice again. I am having this same problem from the same model # television. The code blinks one blink then two blinks pause one blink then two blinks pause one blink then two ...
...will blink a series of blinks pause briefly then blink another number of blinks then pause then it will repeat the same two digit blink sequence a few times . Let me know the two digit blink
Question about WD-52628 52" Projection HDTV
...may be flashing an error code which is identified by the number of blinks between a pause. If two pauses and two different numbers of blinks, it is a two digit fault code like a 26 or 42 as
Question about WD-52628 52" Projection HDTV
blinks~two short blinks = the error code is [12]. These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions