twin needles only one line of stitching is stitching normally, the other line is jumping stitches. I have tried rethreading & changed the twin needle. With the first twin needle the left hand line
Question about Quilt & Craft Pro 7530
how to adjust placment of twin needle so it doesnt hit edge of bobbin holder? twin needle is straight; however, it hits the edge of the bobbin holder on my Kenmore Sewing machine. This is my first ...
...twin needle which comes as two needles on a single needle shaft, correct? That is terrific and you have a wonderful machine. Remove the needle in the machine just the same as you have been over the ...
Question about Quilt & Craft Pro 7530
...Computerized SQ9185 with twin needles you thread the first needle like you would a single needle and then you thread the 2nd needle then same way make sure the setting are fixed for a twin ...
Question about Quilt & Craft Pro 7530
How do I use a twin needle on a Singer 4411. I would like to know how to thread a twin needle on the Singer 4411. try this link out. Stitching Odyssey How to use your twin needle or this one. ...
Question about Quilt & Craft Pro 7530
...twin needles will hit the presser foot or needle plate if the stitch width is set too wide. Be sure you are using a presser foot with a wide opening. Stitching Odyssey How to use your twin needle How ...
Question about Quilt & Craft Pro 7530
Twin needles come in different widths so if yours is too wide, it would break. However, it could be possible that your machine is slightly out of alignment that does not show up until you try to use a
Question about Quilt & Craft Pro 7530
...needles!
You also will have to thread the needles manually as the needle threader will not work on twin needles.
ALWAYS RAISE the presser foot when threading the top
...through the holes in the presser foot and needle plate. Some twin needles are wider than others. Also, be sure to thread one thread completely and then thread the second so they do not become
Can I use a twin needle on a Pfaff 2056 Since your machine can do decorative stitches, I would think it can take a twin needle. Just BE SURE you have installed the needle plate with the wide hole for ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions