...TV have a fuse that can be replaced, possibly power supply? This thing cost too much to throw in the trash! I hope is only a fuse and it will not be hard to find it should be close to where the power ...
fuse insiude the set blew. You can unplug the TV set, take off the back of the TV. Then where the line cord comes out of the TV set and plugs into the wall, look where the line cord enters the set and
fuse in these tv's that could have blown Yes there is a fuse in most of the sets for protection that might either be a glass fuse or a fuse soldered to the board. If the fuse is intact suspect a fault
Question about 53UWX10B 53" Rear Projection Television
...fuse and it look ok. Should I just buy another tV You have other little fuses that you can check in the power supply.In this model I think there are 5 of them.They are little yellow fuses soldered ...
Question about P42H401 42 in. Plasma HDTV
...TV have power (we checked) It is like a fuse has blown or something, but where are the fuses and what kind of fuses would it take check power supply & fuses inside television. Unfortunately the ...
...fuse detects the temperature in the TV and tells the TV to shut down if it thinks it is too hot. Most likely caused by poor ventilation or clogged fans from household dust. Try moving TV away from ...
Question about 57TWX20B 57" Rear Projection Television
...tv up and take out the internal fuse or fuses...go and get the right type of fuses...(the fuses will be made of glass and the same size of a plug fuse) DO NOT USE PLUG FUSES....if that fails then you ...
...TV is plugged into. Replace the fuse or reset the breaker if necessary. 4. Replace the batteries in the remote control, and then try turning on the TV using the remote. 5. Unplug the TV, wait five ...
...down because of faulty capacitors in power supply. if you dont have any lights at all , check fuse in plug, ( there will almost certainly be a fuse in the tv) but, that is for a tv guy to fix. ...
Tv will not turn on ITS THE FUSE IT WILL TAKE ABOUT 5 BUCKS FOR 4 FUSES AND JUST TAKE THE BACK PANEL OFF AND THE FUSE IS BY THE POWER CORD ON THE MOTHERBOARD. AFTER YOU TAKE THE OLD ONE OUT READ THE ...
Usually answered in minutes!
727 Questions
631 Questions
405 Questions
415 Questions
357 Questions