Question about Audio Players & Recorders
...motor that mounts under the turntable do not work. When I turn on the record player, the turntable will not turn. The little motor whick mount up under the turntable is getting lots of fire, but will ...
...turntable motor is weak and failing at this point, simply replace this damaged motor. this will eliminate this distraction. Hi, Well it seems that there is some fault in the turnable motor, ...
Question about Spacemaker JVM1640SJ Microwave Oven
...turntable motor in the bottom of the oven that drives a turntable support directly in some models, and a plastic coupling that rotates the turntable in others. Turntable motor failure is common, or ...
Question about Spacemaker JVM1640SJ Microwave Oven
...turntable motor. The Microwave Wizard website explains that the motor compartment should be positioned below the center of the microwave. Unscrew the motor, disconnect the wires, and remove it from ...
...turntable motor.On OTR models, you can get to the motor by un-screwing the bottom panel on the microwave. On countertop models, there will either be a knockout or screw on access panel. Check for ...
...turntable motor.On OTR models, you can get to the motor by un-screwing the bottom panel on the microwave. On countertop models, there will either be a knockout or screw on access panel. Check for ...
Question about Spacemaker JVM1640SJ Microwave Oven
...Turntable Motor If the microwave turntable doesn't turn the turntable motor might be worn out. This is a common problem and relatively easy to replace. Touchpad and Control Panel If the microwave ...
Question about GF-350 CD Shelf System
...stationary then the drive belt from motor to turntable has probably fallen off of broken. Lift the turntable, there's normally a metal clip holding the turntable in place, and locate the drive
...motor for MMF-5 turntable Power supply for my MMF-5 turntable is 16 volts. Some idiot put 240 volts on it and burned out the motor. Where can I get a new motor and belt. Can I suggest you visit and ...
...turntable motor coupler: The coupler connects the motor shaft to the turntable. If this coupler is worn or broken, the motor will not be able to turn the turntable. Inspect the coupler and replace it ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions