...turned off by itself while we were watching it. I let it sit again for about an hour and turned back on. It stayed on for 4 hours until I turned it off. I haven't been able to turn it back on since. ...
Mitsubishi WS 65513 turns itself off TV turns itself off after about 45 minutes (green light remains on). I can turn off the TV and turn it back on immediately, however, the TV turns itself back off ...
Mitsubishi Medallion does this Hi my name is Todd ,When you turn power button on you hear relay clicking it turn on then turn back off (green power light turns on and off with it) Bad output chip? Bad
Question about Diamond WD-65831 65" Projection HDTV
...turned off. We turned it back on, and then it turned itself off. When it's off, is stays off. I have a Mitsubishi Diamond 65" projection TV. Thanks for your help! check the lamp and air filter if ...
Question about TS-5545 55" Rear Projection Television
...off immediatley after turned on I have a 55" rear projection Mitsubishi TS5545. It turns itself off about two seconds after it is turned on. Any solution for this? mitsubishi projection TV turns off ...
turn it goes back to the other side and stays on. Im not sure what happened. It was fine before i turned it off. Short in the turn signal switch. Should cost around $75 to replace and about 20 minutes
Question about WT-42311 42" Rear Projection Television
...turned off by itself and wont turn back on. It sounds like it its going to and the green light turns off but goes off before any picture comes on. my Mitsubishi Didital vs50111 cut off as fast as you ...
Question about WS-65513 65" Rear Projection HDTV
TV turns itself off after about 5 minutes (green light remains on). I can turn off the TV and turn it back on immediately, however, the TV turns itself back off after a few minutes. It started turning
shut off when the car is turned off the headlight high beam remains on and the turn signals have no neutral position and wont turn off when the car is turned off either. defective multifunction switch
high beam not working whenever i turn my brights on all the lights turn off? This may be your relay, when you change your beams it actually turn 1 beam off and turn the other on to stop over heating ...
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions