Questions & Answers for: can t turn scanner on

...scanner only when you are sure it is not working properly. 1. Turn off the scanner. 2. While holding down 2, 9, and Hold, turn on the scanner. It takes about 3 seconds to initialize and CLEAR

...turn it on then displays unlock scanner - tried to but will not unlock Found this: http://support.dell.com/support/edocs/systems/a940/a940en1.pdf Page iv identifies the location of the scanner lock ...

...Turn the scanner OFF - While holding the 2 and 9 keys down, turn the scanner ON. CLEAR will flash for about 5 seconds as the scanner clears its memory and restores factory settings. Do NOT turn the ...

...turn on the scanner. CLEAR flashes for about 5 seconds as the scanner clears its memory. Note: Do not turn off the scanner again until CLEAR stops flashing. Otherwise, the scanner might not clear its ...

Turn the scanner OFF. 2. While holding down the 2 and 9 keys, turn the scanner ON. CLEAR flashes for about 5 seconds as the scanner resets. DO NOT turn the scanner OFF until CLEAR stops flashing, Need

...scanner 1. Turn off your scanner, and then turn it on again. 2. Insert a pointed object into the reset hole on the back of the scanner. Then, gently press and release the reset button. Pressing reset ...

...scanner only when you are sure it is not working properly. 1. Turn off the scanner. 2. While holding down 2, 9, and Hold, turn on the scanner. It takes about 3 seconds to initialize and CLEAr

...scanner to check the fault code; (5) Turn off the ignition switch for troubleshooting and analysis, then turn on the ignition switch, and use the scanner to erase the stored fault code; (6) Take off ...

...Turn off the scanner by pressing and holding the "Power" button until the scanner turns off. Press and hold the "Func" button while turning on the scanner again. Keep holding the "Func" button until ...