Charging System Plymouth Barracuda I am working on a Barracuda. It has an external regulator with an ignition and a field terminal. The alternator has the batt. and 2 fld terminals. The wiring is all ...
...turn the ignition key but do not crank over the engine. The fuel pump should engage when the ignition key is turned just before cranking over the car. If there is no fuel then the fuel pump and fuel ...
...are spec, and not sticking when hot and opening and closing properly on the shaft when engine is turning
Hi, my 88 gran fury doesn't start unless I hit the gas while I turn the ignition key. Does anyone have a solution for that? Thanks! Should check and see if the electronic choke is working
...fury. Hi, my 88 gran fury doesn't start unless I hit the gas while I turn the ignition key. Does anyone have a solution for that? Thanks! try giving it a full tune up and carb /fuel injection ...
Where is the ignition module at on my 1987 plymouth gran fury which is a 318 automatic? On The late 80's gran fury The ignition module was part of the computer that is attchced to the air cleaner. I ...
turn your key on and just bump the starter a couple of times and you should be fine. Had to do it on many cars before I was able to afford air tools. make sure the breaker bar is in the right position
...ignition key turns, but nothing happens, other than the steering wheel unlocks. If it is the switch how do you remove the 1 piece column plastic cover? When you turn on the key to the start position ...
ignition coil wiring diagram 1987 plymouth gran fury red wire on coil disconnected. need to know where it runs to I just looked on my 86 gran fury--I have a blue and a black wire. They both run ...
...does the ignition actuator do? the actuator is the rod that runs from the key switch to the ignition switch at the bottom of the steering colume that moves the slide in the switch to start the
Usually answered in minutes!
25 Questions
25 Questions
13 Questions
3 Questions
2 Questions