Question about Arcitec Electric Shaver with Jet Clean System - Gray/Black
...head on, the three individual heads do not turn. At one time, the motor shaft was not turning but after awhile it started turning. The razor was working fine until after a charge it started with the ...
Question about Arcitec Electric Shaver with Jet Clean System - Gray/Black
...head to turn...if that is not the problem turn the cutter head by hand and check to see that the bearing inside the cutter head has not seized, it should turn freely with no noise....if no joy check ...
...head bolts to 60 Nm (44 lb-ft) following the sequence shown. After tightening, turn all bolts 90 degrees, in the same sequence. Complete bolt tightening by turning them an additional 90 degrees, in ...
...TURN.YOUR HEAD GASKET LEAKING CAUSING PISTONS TO HYDRASTATIC LOCK.IF ENGINE TURNING OVER.CHECK CYLINDERS MAKE SURE YOU HAVE COMPRESSION.IF NO HEAD GASKET LEAKING AGAIN.IF CYLINDERS HEADS WARPAGE ...
are the heads suppose to turn. I cleaned the razor and the heads. It seems to shave, but the heads do not turn. The round discs that touch you face are not supposed to turn. Only the blades on the ...
...turn head, loosen screws a little more. If scres are removed and heaf still not comeing off, Use pipe wrench or afjustable pliers wrapped in cloth to preven maring and loosen. (looking from top, or ...
Question about Manfrotto 3130 Micro Fluid QR Head Tripod Head
...head won't turn When you say it wont turn, i assume you mean the engine is running but the head isn't turning.?? Check the drive shafts and the clutch. Does the cutting head turn by hand or has it ...
Question about Manfrotto 3130 Micro Fluid QR Head Tripod Head
...turn ft lbs Here are the four steps you should take: 1. Cylinder Head Bolts* 45 ft-lbs 2. Cylinder Head Bolts* 65 ft-lbs 3. Cylinder Head Bolts* 65 ft-lbs 4. Cylinder Head Bolts* +1?4 Turn +1?4 ...
Question about Manfrotto 3130 Micro Fluid QR Head Tripod Head
...turn signals work with head lights off, and only work for left turn with the headlights on? The headlights should be a separate circuit from the turn and flasher circuits. Head light switch turns on ...
Question about Manfrotto 3130 Micro Fluid QR Head Tripod Head
...clock wise or counter Place an Allen wrench in the opening on top of the head and slowly turn the head until wrench slides into the slot. Turn the weed eater head counter clockwise to remove the
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions