Questions & Answers for: Aquabot turbo timer

how do you change the rubber traction belts on the aquabot turbo t2. First of all your cleaner is under warranty for 4 years or 300 cleaning cycles and is prorated. That being said, here is the ...

Aquabot Turbo T won't climb My Aquabot Turbo T starts up okay. It moves along the floor and climbs walls. After a few minutes it seems to lose grip and gets stuck between floor and wall, spinning its ...

won't go in shallow end to clean Our Aquabot Turbo T cleaner only stays in the deep end of our 20 x 40 pool while cleaning. It is 1 year old. Last year it worked fine. If your floats have started to ...

My turbo bot does climb the walls of my pool. I have had it checked out with service. they could not find any problems. Any suggestions? Not too uncommon. The float design is such that many units lack

...turbo starts to work and then stops. Sometimes if I turn if off and on it will work again but only for a few seconds and then stop. I have a timer but no remote with my power supply. Is it the fuse? ...

I have aquabot turbo with remote control. remote control battery was recently replaced and red light on the remote indicates that remote is working. However the piston on the aquabot don't more. ...

troubleshoot aquabot turbo won't pump water moves slow bad pump motor possible bad drive motor also

How to shorten power cord on aquabot turbo t the power cord is factory installed to that length. there is no need to shorten it

How come my aquabot turbo will not move or pump water? My unit will not move or pump water. The fuse is good. When I turn the unit on and push the reset, there is a humming. Probably the drive belt ...

why does aquabot turbo shut off within 1 minute of starting? not equipped with timer. bad motor