Question about Pressure Washer Turbo Nozzle
...as though there is a vapor lock in the wand. the water supply is disconnected and there appears to be pressure is the washer hose. The wand is dirty!! Clean out the Nozzle with a small diameter
Question about Pressure Washer Turbo Nozzle
...Turbo nozzle emits a solid stream of water without any turbo action. NorthStar Pressure Washer Turbo NozzleTurbo nozzle sprays up to 3.1 GPM at 2300 PSI and 194°F. Unique design delivers 0° ...
Question about Pressure Washer Turbo Nozzle
...turbo nozzle how do you take apart the nozzle. Most commonly, debris gets plugged internally in the nozzle holes. Using a small pick from the outside, with the nozzle removed from the wand (it is ...
Question about Pressure Washer Turbo Nozzle
Where can I get an orifice (nozzle for idrojet, blue, #4.0 - part# 22593 for a NorthStar pressure washer 157557? www.powerclean-engineering.co.uk Turbo nozzle
can't unscrew nozzle from hose what do I do to loosen? I used a vise and pipe wrench to loosen. Have to be careful with the vise that you don't over tighten it and damage the hose fitting. When ...
Question about Powerwasher Universal Turbo Nozzle with Lance - 81K020SH
nozzle does not spin Sounds like you may have some dirt inside your turbo nozzle.
...turbo motor runs good sounds like it should be full pressure Hi and welcome to FixYa, I am Kelly. From your description of the problem: "motor runs good sounds like it should be full pressure" This ...
Question about Pressure Washer PSI 3000
...turbo nozzle When using conventional tips the pressure washer works fine. If I attach a turbo nozzle the pressure hose will burst. Turbo heads are pressure rated for different pressure washers, your ...
Question about 3000 Turbo Nozzle and Quick Disconnect Adaptor SGY-PWA46
I primed the engine on a 2650 psi pressure washer and put on the nozzle. Why does it pulse? Every pressure washer I've used pulses...
Question about 3000 Turbo Nozzle and Quick Disconnect Adaptor SGY-PWA46
turbo wand and nozzle connection on my Pressure washer Model 580.752070 How to restore seal between Wand and nozzle? Please point me in the right direction to resolve this problem Turbo Wand and spray
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions