Questions & Answers for: can t get trimmer head to unscrew

trimmer head (T35) to attach the blade? Husqvarna 325rj X Series Use a large pair of pliers to hold the turning metal ring above the T35 trimmer head. I used a medium-sized pair of Channel Lock pliers

head off of the trimmer, but cannot figure out how the head seperates from the assembly. Any suggestions? There is a nut above the head, place a wrench on the nut then unscrew the head from the shaft,

your trimmer model's replacement head to make sure you're trying to unscrew the head the wrong way.  Many models, with replacement heads, can be found at PartsBuggy.com's website here

...trimmer head, in the gear box where you can insert a screwdriver or something to lock the shaft from spinning whie you unscrew it. Some trimmer heads require you to disassemble the head and remove a ...

...unscrew the head opposite of whichever way the head normally turns while you're trimming. This is by design so that the machine doesn't unscrew the head itself while you're using it. ...

...trimmer head using the wrench. Take the entire head off the end of the shaft. On the link below you can get the manual. It will tell you how to remove the head. You will also need the serial # ...

...trimmer head so asthe pin enters the driver flange below and locks it, now grab the complete trimmer head and turn clockwise ( left hand thread ) the trimmer head will unscrew from the output shaft ...

trimmer head from my TB32EC Troy Bilt trimmer to clear grass build up inside of plastic head? Depending on the style of head, you either unscrew the cap on the end. of you push 2 clips in and pull the

...trimmer head to unscrew. I used an allen key to lock the head but the trimmer part does not unscrew? The trimmer head just spins but does not unscrew.Please advise There should be a small hole on the ...

...head on a ryobi string trimmer Holding the line head trying to remove the knob to unscrew it just clicks and won't come loose If the knob is stuck in the pushed in position it will just click , try ...