...finger holds the trigger which holds the gear(clutch) from rotating. Dirt and lubricant has gotten in there and the grey trigger cannot return to its position in time. Eventually it may if you let it ...
...finger off the trigger which moves the triger which allows the clutch to engage and turn the thick gear, driving the mechanism. What's happening is that over time the light grease has thickened and ...
...Trigger is froze and the ram part # 234 is extended and will not return. if you can push the ram back with your finger , then may be your return o ring is damaged, if you cant push it back with your ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
Finger trigger has come apart. Diagram needed to reassemble. Porter-Cable Model FN250A finish nailer. Need diagrams to reassemble finger trigger. The springs have all come out of the red plastic ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
...trigger sticks and will not return to the ready position after firing - I have to flick with finger for it to pop back or fire with finger tip and remove the finger as I fire for it to pop back Your ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
...finger from the trigger. That's the reason I keep the trigger pulled and bounce it. I know that after the bounce I've set a nail, and can remove my finger from the trigger. When I need to accurately ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
...trigger, fire the gun against wood with finger to test for proper action. If it works better without trigger, consider replacing trigger with new (I would also order the oring repair kit that ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
trigger firing pin. Connect air and test fire by pushing in the firing pin with your finger (dry fire onto wood or old coiled rubber hose, use very quick pushing action against trigger pin).
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
...trigger finger. The tendons that cause your fingers to be able to bend run through small openings in the bone. The tendons can develop small nodules or bumps on them that are larger than the opening ...
Question about Cable-Cable FN250C 1-inch to2-1/2-inch 16 Gauge Finish Nailer
...trigger, I have full pressure. If I put my finger over the rubber tip the air flow stops I have a Coleman Black Max Powermate 3.5 HP model B3511. When I hook up a blowgun and pull the trigger, I have ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions