...transmission jumps/surges when it shifts from 2nd to 3rd, but only if it shifts below 4500 RPM. It is not a clean shift into 3rd. It will rev up a little before going into 3rd. Otherwise, the other ...
My 96 BMW slips in 3rd gear then engages. When it shifts to 3rd gear the rpm's go really high and then it engages you need to start saving for a transmission, have a teck drive it, to make sure.
Question about 1996 Town Car
...3rd It is in "limp" mode which limits the transmission to only 3rd gear. The transmission fluid level needs to be checked and the "basic settings" need to be reset in the Transmission Control
...transmission to not shift gears correctly. Ours took off in 3rd gear when put in Overdrive & only ran in 3rd gear. If we tried to manually shift thru gears (auto trans), it had 1st, 3rd, reverse. ...
Question about 1997 K1500
transmission will not stay in 3rd gear Check the 3rd gear shaft indent spring is not broker, and there is no play on any linkage stopping the gear from fully engaging , If all is OK there the box will
Question about 1997 K1500
transmission shifts harshly into reverse than stays in 3rd gear going forward? This is an automatic? I have experienced manual transmissions that became engaged in two gears simultaneously that had to
Question about 1997 K1500
...3rd gear. without trailer attached first gear engages. please help. transmission over heating.too much weight for the pull. you could install transmission cooler kit.or you need more horse ...
Question about 2002 Golf
...transmission not engaging 3rd and 4th gear. I did oil and filter change, and yet the problem persists. Any idea on what next to do? Question edited with a GUESS at the make and model. Question moved ...
...3rd shift solenoid without any improvement, it may be best to have the transmission inspected by a professional mechanic or transmission specialist who can perform a more thorough diagnosis and ...
...3rd gear have a grinding noise this manual transmission? seems. so the tip of shift levers love to get worn and not allowing the shift rail forks to hit 3rd gear. a pure simple mechanical failure and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions