Questions & Answers for: Lutron transformers

What Kind of Dimmer? What kind of dimmer should be used to control low voltage lighting? If the low voltage lighting system uses an electronic transformer, then a dimmer designed for this type of ...

Dimmer Installation How should dimmers be connected electrically? Dimmers should always be connected to line voltage (usually 120 volts). That is, when a dimmer is used to control a low voltage ...

and recorrect themselves in 5-minute intervals. It sounds like the transformer is overheating. Many transformers have a resetable thermal cutout built into them so that if they start to overheat, they

...leak when off. There appears to be about 8 volts still going to the fixtures. That causes the transformers on the fixtures to sing when off. Probably not good for transformer life & very ...

7-50W 12V MR 16 lamped fixtures on a Juno Flex 12 Trac all went out after working fine 4 yrs. Transformer is buzzing when swithed on at either Lutron SLV-603P or other 3-way switch. Other switch does ...

i have two dimmer switches in the same box side by side. one goes to three pot lights, the other goes to a halogen track light. these have been working for 5 years. the lights have burnt out and been ...

Removed the switch plate and connected the two wires going into the dimmer box and the lights still dont come on. I as thikning by bypassing the dimmer the lights should still function. What else ...

...which will look like a short on a DC-supplied continuity test. The input to an ELECTRONIC transformers is a switching power supply, which will not look like anything when supplied by a DC ...

...you're not dimming a 12 volt circuit - but rather a 120 volt circuit that supplies one or more transformers that step the power down from 120 volts to the the 12 volt bulb voltage.  A ...

12 V halogen track (8 bulbs; replaced withLED); turned on Lutron dv600p dimmer; lights lit & frying sound; then off. all bulbs still good. Differential diagnosis for transformer vs Lutron problem? ...