Questions & Answers for: Chevrolet S 10 trans limp mode

...4l60e trans (tld code) new fluid and slick 50 old trans cond added 4x4 Your stuck in 4x4 mode or it's only partially engaged. You need to have the transmission checked to see why this is

the trans is seperated about 1/2 an inch and is stuck mananual trans 2003 s-10 2wd 4cyl Push the trans into place and re thighten the transmission bolts. This may require loosening the rear trans ...

i need to replace the front transmission seal in my 1984 chevy s10 how do i do it I'am assuming its an automatic, in any case the transmission has to come out, after thats done, slip torq converter ...

...free. it could be a bad cam or crank sensor. have it scanned. if a bad crank sensor it will shut off when warm going down highway. it goes in to limp mode, and will not send the pcm the correct

I have several S10's from an 84 to a 99 which are all prone to both engine and trans failures. As either a trans or an engine went bad, I have kept them as parts trucks now I have a few that need ...

Where do I locate the transmission fluid dip stix? I need to check Trans.Fluid. is it automatic ao manual trans? the auto should be in the rear of engine compartment on the right side/ if its is a ...

how to replace a front transmission seal on a 1993 s10 4.3 v6 came off the trans and remove the torque converter remove de seal don care if you broken the old one and put the new one be safe of dont ...

...matic trany, it could have went into limp mode. This is usely fixed by replacing the shift control module. it plugs into the side of trany pretty easy to locate when you have the new one in your

limp home mode 2001 Chevy S10 4WD Auto 4.3L, Stuck in Limp Mode (only drives in 2nd), Code P0756: Shift Solenoid B Performance Stuck Off. Checked all fuses, checked both Shift Solenoids (both show ...

...limp mode Is the check engine light or service engine soon light lit on the instrument cluster ? How many miles on the trans ? If no lights , probably trans internal problem . Rather then guessing ...