Questions & Answers for: Plymouth trans limp mode

Question about 1999 Breeze

1 Answer

...to get to after you jack the car up. The trans. computer is detecting something is wrong and puts the car into "limp in" mode. I've seen alot of these speed sensors go out on the Chrysler

Ad

Question about 1992 Voyager

1 Answer

...find the error code 15. Replace your input and output speed sensors on the trans. The reason why it won't shift is because the trans. is in "limp in" mode. The trans. computer is detecting a

Ad

Question about 1997 Voyager

1 Answer

...rest of the van trys to catch up on acceleration and as it shifts, could this be a mount? if not what else? flush it, new oil, and add a can of trans fix if it doesn't shift or drops in to limp in ...

Question about 1999 Voyager

1 Answer

LIMP MODE voyager will not upshift, getting code P0700 ( '99 3.8l ) Transmission Control System Malfunction.It means you have a trans control problem in the trans computer. You will need to get it on ...

...to higher gear 94 plymouth voyager won't shift to higher gear.can i fix it.. Trans is in limp mode. Speed sensor problem with the transmission. Take it to the dealer. I had mine done for 186

Question about 2000 Voyager

2 Answers

...Limp Mode and now p1787 and 2(two) p0700. replaced input, output, tcm and solenoid pack. no money for dealer whats other option besides tnt? YOU NEED TO CHECK POWER AND GROUND CIRCUITS TO TCM have a ...

Question about 1999 Voyager

1 Answer

...gear(auto trans) after that the 'engine service soon' lit on? please help...thank you. your trans is in limp mode disconnect battery reconnect see if it reoccurs check trabs computer and all ...

Question about 1999 Voyager

1 Answer

...trans is in limp if i reset it the trans shifts great once you restart it back in limp This usually points to a sensor issue or a computer failure. What diagnostics have been done with a diagnostic ...

Question about 1996 Grand Voyager

1 Answer

...trans is in limp-in mode. Disconnect the trans 8-way connector at the solenoid pack. Key on scanner hooked up apply 12 volts to the L/R pressure switch pin in the 8-way connector and watch for the ...

then stayed in 2 nd wires are showing on the clip that connects to input sensor Second gear is considered a limp mode other possible causes is the solenoid pack hook up a scanner and check trans codes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...