Questions & Answers for: toyota camry map sensor

...toyota camry 4 cylinder A 2000 Camry with a 4cyl does not have a EGR sensor. The ECU uses the readings from the MAP and AF sensors to determine if the EGR is working. You have a EGR VSV (vacuum ...

Ad

...Camry,2.2 hesitating off of idle. california emmisions(has no MAF sensor),code p0172, fuel pressure within specs(50 psi), MAP sensor has been replaced. Runs the same with O2 sensor disconnected. Do a ...

Ad

Toyota Camry? The 4 cylinder Camry uses a MAP sensor or Manifold Air Pressure sensor instead of a air mass flow sensor which is in the 6 cylinder model. It is located just under the top of the hood in

...Camry uses a MAP sensor or Manifold Air Pressure sensor instead of a air mass flow sensor which is in the 6 cylinder model. It is located just under the top of the hood in the center of the bay ...

located on a 91 Toyota Camry ? It's on the firewall, center of the car. Follow the vacuum tube from the engine. It's very small.attached to the firewall next to the throttle body.----------- Thank you

...toyota camry le v6, what is the fault This is a fault with the Oxygen sensor on bank 2 Have a 1993lev6 already replaced o2 sensor . Mite b map sensor that is next plus anither tune up already checked ...

Question about 1998 Camry

1 Answer

...MAP sensor itself.Precise testing procedures cannot be posted because yu did not mention WHICH ENGINE your Camry is equipped with or which Diagnosic Test Code (DTC) you are getting from your

...Toyota Camry: Order Coolant Bypass Tube? http://whatisbyme.blogspot.in/2012/05/1991-toyota-camry-order-coolant-bypass.html ------------- 2002 Toyota Camry: Puff of Blue or White Smoke while Starting? ...

...Toyota Camry Not running properly. Diagnostic test shows 00 Toyota Camry shows Maps Sensor. I changed the sensor and the car runs well for a few hrs but begins to stall and start again.......rough. ...

toyota camry 2010 starts for a few seconds and then turn off on its own Possibly sensors or their connectors, - O2, timing sensors, fuel pressure too low, MAP, loose ground wire on block.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...