...touch scanner on my vista laptop. the install was not a problem. I've tried to use the scanner, and the icon won't open, is this old scanner compatible with a vista computer program? Do I need to ...
...set is turned on, green horizonal lines appear for approx 2 min trying to figure out why. Did you touch the lamp? or Lenses just outside the lamp? Is the lamp the correct one? If so...clean ...
Question about WD-52525 52" Rear Projection HDTV
horizon treadmill T90 won't start number reads 5105-04 touch a 9 volt battery to the motor wires and see if the motor moves. if so, it's good and the board is bad. We are a authorized service center ...
Horizon Treadmill T5.1. A sudden vibration and loud noise started coming from what appears to be the rear roller. To find a specific bearing that has gone bad in a treadmill you can use a long handled
...back is hot to the touch. Is there any way I can save this or is a new minifridge on the horizon? these unit are not normally a serviceable piece off equipment they are not cost effective to
Making a loud whirring noise when running. hi i think that the running belt is too loose and touching the underbody of the treadmill, if you can have a look underneath.
...horizon 2 over head projector and it keep shorting out the bulbs. it did not come with a manuel so im trying to fix it on my own can anyone help me???? How long the lamp works for? Check if cooling ...
Question about Horizon 2 OpenHead Overhead Projector
...touch horizon glocumeter. The OneTouch Ultra uses a three-volt lithium battery. When this battery requires replacement, you'll see a flashing message on the display screen. Changing the ...
Question about Horizon T103 14 Program Treadmill
...Horizon T103 treadmill from Miles to KMs you must go under the display board, or monitor, see the small orifice, and put the point of erase pencil in the small orifice and touch the small switch, and ...
...stupidly cleaning under the motor cover whilst plugged in and the metal Henry vacuum cleaner end touched something in the circuit board and I got a pop and a flash. The top control panel all works ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions