...torque is as follows , step 1 = 18 ft. lbs. , step 2 = 70 degrees , step 3 = 70 degrees , step 4 = 30 degrees . sequence is as pictured . there ya go , gears to the left , looking at the front of ...
Question about 20 Hp 42" Deck Lawn Tractor
...torque to prevent slippage so that the blade rotates at the same speed as the spindle. When slippage between the blade and spindle occurs, blade tip speed slows leaving uncut grass. Note: this ...
spindle and crank arm meet as well as the crank arm bolts. Use a high quality grease (not oil, such as Triflow) or anti-seize compound. Torque the crank arm bolts to the factory spec. Crank arms bolts
...spindle hub bearing assembly on the front wheel of a 1994 Buick Le Sabre. I need the torque spec. for the 3 retaining bolts and hub nut. Well the torque for the three retaining bolts should be about ...
...spindle bolt. If anyone also has the torque-specs for the lower ball-joint bolts that would be great too. Thanks! Axle shaft bolt should be torqued to 147 Ft Lbs plus 1/4 turn. The six CV joint bolts ...
...torque specifications for the spindle bolt is critical to bearing life. You cannot grunt-torque them and expect them to last. Use a calibrated torque wrench at the proper torque. I personally ...
bearing torque specs for 2005 equinox The 3 bolts that hold the hub to the spindle torque specs are 96 ft lbs. The CV shaft nut is 118 ft lbs. The caliper bracket bolts should be torqued to 137 ft lbs
...3 BOLTS For a Spindle on a Vehicle; Torque to 2 pounds, spin the wheel, Torque to 10 pounds spin the wheel check for 10 pounds again and back off the nut to finger tight and install the counter
...spindle... continue to turn bolt with fingers until it is snug. Then tighten to 50 ft/lb... which is hard to do with a short (less than a foot) wrench. You should have a 18" breaker bar or better a ...
Question about 1997 C1500
...spindle nut torque procedure? - CK5 Network https://ck5.com > ... > General Discussion > The Garage Jan 31, 2005 - while rotating the hub in a foward direction torque the nut to about 12ft lbs. Keep ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions