Questions & Answers for: Chevrolet Cavalier tire rotation

terrible front end noise 2004 cavalier Front end tires sound like they're rumbling; however, I just had them rotated and no change. The noise wasn't there when the tires were installed. Have your tire

i have a camaro and the light of low trac comes on so i want to know what it is Low traction means the the on-board computer has detected that one or more tires are rotating at a different speed. If ...

...and they cant find anything wrong, Drove it for 2 days and then it started doing it again. Are your tires directional check and see if they are there will either be a arrow pointing the tire in the ...

rear tire won't come off on my 2001 chevy cavalier The rear tire won't come off on my 2001 chevy cavalier. I removed the lug nuts, but there appears to be something in the middle holding it in place. ...

WHAT IS THE PROPER WAY TO ROTATE THE TIRES , ON A 1991 CAVALIER You always keep the tires on the same side and swap them from front to back. Rotate them about every seven thousand miles. If the front ...

I bought 4 tires at the same time, just had them rotated and was told that the front tires have more traction on them now than the back and that they shouldn't of rotated them. On a 2001 Chevy ...

I am trying to find what tires will fit on my Chevrolet Cavalier, 1996, Coupe Base. My Girlfriend's dad is going to put new tires on her car, and her tires are in better shape in mine, and was trying ...

1997 cavalier, both rear tires wearing on the outside 1/2 of the tires. What would the probable culprit be? The car has 97k miles on it... if you don`t rotate the tires this can cause abnormal tire ...

FRT END SHAKES AT ALL SPEEDS If steering wheel shakes bad tire on front. If whole car shakes bad tire on rear. Or tires could be out of balance. If steering wheel shakes when brakes applied, front ...

front end shaking bouncing or shaking in front end Check to make sure your tires are in good condition and Balanced. Might need to rotate the tires. If not could be a bearing.