Question about Radio TK 260 360 270 370 2100 3100 Compatible Battery
need manual for kenwood tk-270 transceiver does any one no were i can not work it Field Programming procedure for the Kenwood TK-270 or TK-370 handhelds. Press and hold (light) & (dial) while ...
Question about Programmable 24 Wall Switch Timer Ej351c
Hello I lost my instructions for theej351c, can you help? 1. Move control lever to OFF-CLEAR for at least 5 seconds; red indicator light will go off, and all previous time settings will be cleared ...
Question about Programmable 24 Wall Switch Timer Ej351c
I just bought a house with the Night Sentry EJ351 timer. There was no instruction manual with it so I do not know how to set the timer. It is hard wired in the garage and set to operate outside ...
I bought a house with a Night Sentry Solid State Timer model # EJ341 and have no instructions on setting or programming the unit. rapid Programming. 1. Move control lever to OFFCLEAR for at least 5 ...
How do you perform a full reset on a kenwood tk-370 Field Programming procedure for the Kenwood TK-270 or TK-370 handhelds. Press and hold (light) & (dial) while turning on radio. Hold until (SEL)
I have the EJ351 model and when it is programmed the lights come on at the desired time; but it never turns the lights off. Manually it works fine and turns the lights on and off. ...
I need the directions so I can program the timer The manual is available here: http://www.intermatic.com/products/timers/consumer%20indoor%20timers/in-wall%20timers/st01c.aspx . See the right side of ...
timing is off replace cam change and the bike is popping Valve timing is off then so you need to redo your work and time the cam properly. You could be out a tooth, either on the rear side chain or ...
Question about 2001 FLHRCI Road King Classic
iturned ignition key on off on off on off,and,check engine light blinked twice,then twice again,then blinked five times,then four times,then five times,then five times,can you tell me what that means ...
Question about 2001 FLHRCI Road King Classic
Malibu 300 transformer. Which way do you turn manual switch to off for timer to work? Test that lights turn on when switch is in ON position. Then turn knob to "TIMER" and set both the time you want ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions