Questions & Answers for: timing 5 7 vortec

...vortec Change the fuel filte also and then EVERY EVERY 15,000 mles and don't worry about the engine oil change that once every 4 or 5 years that is not nearly as important as the fuel filter nothing ...

...5 PSI then u will need to replace the fuel pump in the gas tank. One note make sure the connection for the guage is tight with no leakage or the test is invalid when I go to start my 97 z71 with 350, ...

...5.7 l vortec and have a no 5 cyl misfire i own a 96 chevy k1500 5.7 l vortec and have a missfire on no 5 cylinder. i changed cap and rotor plugs, wires, compression is 150 psi, no vac leak, also done ...

vortec, i have to turn the key to start the pump 4 or 5 times then it will start and run normally. but it won't start unless i turn it as i said. What do you think? It could be a bad fuel pump located

... Unplug connector (tan/black stripe) start engine set timing to 0 TDC, TURN OFF ENGINE, re-connect timing connector Firing Order 1 - 6 - 5 - 4 - 3 - 2 Drivers side: 1 - 3 - 5 Passenger's side 2 - 4 - ...

installed a new DUI Vortec V8 distributor in a 1999 Chevy Tahoe. Vacuumn advance is to high -18 on timing should be -5 to 1 Check to see if vacuum advance has an adjustment.

vortec 5.7 drivers side of engine is- 1-3-5-7, from radiator to firewall. -- 2-4-6-8 is on passengers side, firing order is 1-8-4-3-6-5-7-2, on the coil, drivers side from front to back is 1-7-3-5, on

5 7 vortec misfire has constant miss gives code P1441 twice every time I've done complete tune with crank and cam sensor retimed distributor and knock sensor same miss and a thumping in exhaust every ...

VORTec 5.7L. backfires at startup and now it goes to full throttle...why tried to start this morn.as always, this time it backfired through the intake system, now when I start it, it goes to full ...

...timing order on the distributor and how to time the motor in The firing order for Chevy Big Block V8 engines (396, 406, 427, 454) is the same as the small blocks: 1-8-4-3-6-5-7-2. ...