Questions & Answers for: Mitsubishi timeslips error code 2

Error code 1 2 Had the blinking green light. Pressed Device and Menu and got the error code. Blinking green light stopped and then I pushed power. The TV is working. What is error 1 2? I found this ...

error code, I checked the horizontal output transistor & all Horz. Chkts, all OK....prior to this error i was getting 2-2 so i changed the 2 conv ics and 5a. pico fuses, conv resistors all chk 2-3

...error code: for example: 2 blinks, a pause and 2 blinks--it will repeat the code about 10 times. error codes for this set: 1, then 2 no error detected 2, then 1 X-ray protection 2, then 2 short ...

...error code: for example: 2 blinks, a pause and 2 blinks--it will repeat the code about 10 times. error codes for this set: 1, then 2 no error detected 2, then 1 X-ray protection 2, then 2 short ...

...error code: for example: 2 blinks, a pause and 2 blinks--it will repeat the code about 10 times. error codes for this set: 1, then 2 no error detected 2, then 1 X-ray protection 2, then 2 short ...

error 1-2 error code 1-2 is the no errors detected code. does your set have any other symptoms?

What's the error code for a 2-4 on my Mitsubishi What's the error code for a 2-4 on my Mitsubishi VS 60707 2 blink-then 4 blink---------vertical circuit problem

error code by following the steps below.- Power on the unit and wait until the initialization takes place.- Press the front panel "Input" and "Menu" buttons at the same time and hold it for 5 seconds,

...error code that is short protectionIf you get the 2,1 error code that is X-ray protectionThe 2,2 is most common and the easier one to fix.If in doubt--unplug set and plug back in and try to turn on, ...

...Error Code Operational Check To activate the Error Code Mode, while the set is OFF, press the front panel "INPUT" and "MENU" buttons at the same time and hold for 5 seconds. The LED will flash ...